Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
230
Advanced parameters
J.2 Ascom Line Protocol
J.2.1 Functionality
A line protocol message consists of the following records and separators:
<Addr/Message/Beepcode/PagFunc/NoOfTransm/Prio/Infopage>
All characters are writeable by hand using an ordinary terminal program such as hyper
terminal etc. Not all records needs to be given, for instance <> is a valid message that
delivers default message to default paging address.
J.2.2 Limitations
The following limitations apply:
Number of transmissions
(Record 5, standard ESPA): This record is accepted but ignored since it is not
supported by Unite.
Number of transmissions can be set under System
900 and is then valid for all messages
independent of the record value. Here it is also
possible to determine number of transmissions
based on the paging priority (advanced).
Mailbox number
(Record A, Ericsson dialect): This record is accepted but ignored since it is not
supported by Unite.
Infopage
(Record C, Ascom dialect): This record is accepted but ignored since it is not
supported by Unite.
Bleep each transmission: This parameter was available in 942SI. The parameter is not
available in Unite CM, instead the parameter can be set in
advanced GUI under System 900 Advanced parameters.
Flow control XON/XOFF: Not supported since there are some issues with the control
characters. If the block check character becomes any of the
two control characters XON or XOFF, the flow control fails,
therefore flow control is no longer supported.
PagFunc: The Line protocol only supports call type 3 (plain paging) and
4 (alarm). All others are handled as plain paging.
NoOfTransm: The Line protocol does not propagate number of transmissions
but it must be valid if submitted.
Number of transmissions can be set under System 900 and is
then valid for all messages independent of the record value.
Here it is also possible to determine number of transmissions
based on the paging priority (advanced).
InfoPage: The Line protocol does not propagate Infopage but it must be
valid if submitted.