Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
210
2 Enter a name for the fault action, in this example DECT error.
3 Enter the Unite CM IP address “xxx.xxx.xxx.xxx/DECT” as trigger condition, where
xxx.xxx.xxx.xxx is the IP address.
4 Select the error level to trigger on as “Error”.
5 Select the action Send E-mail and enter the complete e-mail address to the recipient.
Select the Include log info check box.
6 Mark the Error Relay “Indicates Fault” check box to use the output/relay to indicate
fault. Set the duration to 60 s.