Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
173
The outputs can manually be reset from the I/O Setup page. See 4.7 Input/Output Setup on
page 34.
Sending Messages
• First Persistent Fault
- Click “Add Message” in the Action on First Persistent Faults section to send a message
for the first persistent fault. Refer to Message Action on page 170.
- Click “Add E-mail” if an e-mail notification should be sent. Refer to E-mail Action on
page 170.
- Click “Add SNMP trap” to send a SNMP trap. Refer to SNMP Trap Action on page 171.
• No Remaining Faults
- Click “Add Message” in the Action on No Remaining Persistent Faults section to send a
message when all persistent faults are resolved. Refer to Message Action on page 170.
- Click “Add E-mail” if an e-mail notification should be sent. Refer to E-mail Action on
page 170.
- Click “Add SNMP trap” to send a SNMP trap. Refer to SNMP Trap Action on page 171.
23.6 Activity Logging
To be able to view activities stored in Unite CM, it is also necessary to install the Java
Runtime Environment to run the Activity Log Viewer. To find this, go to www.java.com.
Functions in the Activity Log:
• Activity Log Viewer – view and search for activities that are stored in Unite CM.