Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
167
1 Click “Add SNMP Trap Action”.
Figure 76. The action is setup to receive SNMP trap with the status Warning.
2 Enter/select following settings:
3 Click “Save”.
Figure 72.
Setting Description
Module: Enter a name that describes the sender of the SNMP traps.
IP Address: Enter the IP address pattern that should match the IP address in the
received trap.
Filter: Enter a text that should match the trap message. Wildcard (*) can be
used to match a part of the received message. Leave the field empty
if the trap should be received regardless of the trap message.
Enabled: Select if the action should be enabled or not. If enabled, incoming
SNMP traps will be matched with the IP address and the filter
condition that is set.
Level: Select which level the sent Status Log should have or select “No Log”
to not generate a Status Log when a trap matching the conditions is
received.
Event Description: Enter an event description to be included in the Status Log.
Include trap data: Select the Include trap data check box, if received trap data should be
included in the log message