Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
166
Default SNMP Trap Action
The default action will be matched for all traps that are not matched by any other actions
that are set up. In the Status Log, the module will be set to “-” and the IP address and Event
Description will be copied from the received trap.
1 Click “Configuration” on the start page.
2 Select Supervision > SNMP Traps in the menu on the Configuration page.
Figure 74. The default settings for SNMP traps action.
Change Status Level
1 Click “Setup”.
Figure 75. The default SNMP trap is enabled to receive information.
2 Select which level the sent Status Log should have or select “No Log” to not generate
a Status Log when a trap only matching the default action.
3 Enter an event description to be included in the Status Log.
4 Select the Include trap data check box, if received trap data should be included in the
log message and click “Save”.
Add/Change SNMP Trap Action
This is used when SNMP traps from specific modules or with certain messages should be
handled individually. The IP address in the received trap should match the defined pattern
and/or the trap message should match the pattern set up in the filter. By selecting “No Log”
in the Log Setup, traps matching the set up conditions can be discarded.
Figure 70.
Figure 71.