Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
162
Changing Supervision Settings
1 Click “Setup” to set up supervision parameters for the equipment.
2 Enter a descriptive text in the Equipment field. Equipment is shown as Module in the
Status Log.
3 Change IP address or host name if the address of the equipment has changed.
4 Select if the equipment should be supervised or not.
5 Enter the time between supervision requests.
6 Select fault level from the drop-down list to use in the transmitted Status Log.
7 Enter a description of the event and click “Save”.
Removing IP Equipment
Remove IP equipment by clicking the “Delete” symbol. A dialogue window opens, click “OK”
to remove the IP equipment.
23.3 Auxiliary Equipment
Unite CM can be configured to generate a Status Log when receiving an Input Activity. This
can be used by equipment that indicates faults via a physical output to send faults to the
Unite system. For each input that is monitored, equipment name, fault level and event
description can be configured. It is also possible to set that the sent Status Log should be