Troubleshooting guide

TD 92735EN

15 May 2012 / Ver. G

Installation and Operation Manual

Unite Connectivity Manager

2 Installation and Configuration steps

The installation of Unite CM hardware, that is, Elise3, is described in the Elise3 Installation

Guide.

After installing the hardware, the basic configuration is easily done with the help of a setup

wizard. The wizard includes all basic settings needed to get Unite CM up and running.

2.1 Cables and Adapters

NOTE: Not included in delivery.

Cables to DECT Exchange and adapters can be ordered separately, refer to the Data Sheet,

Unite Connectivity Manager TD 92739EN.

If you want to make your own cable, refer to the descriptions in Appendix B: RS232

Connections on page 202.

2.2 Information required for the Setup

Make sure the following information is available:

• MAC address – found on a label on the Unite CM’s rear side, in the application’s GUI in the

Setup Wizard, or on the Configuration page (the first view).

• License number – found on the license certificate

• Network parameters – ask your network administrator

• Type of connected wireless phone system, if any

• IP address to connected system (if connected via IP)

• Other messaging systems to send messages to (optional)

• IP address to mail server if fault information and Activity Logs are to be sent to e-mail

recipients (optional)

•LDAP

properties if an LDAP server is used as Central Phonebook directory (optional)

2.3 Accessing Unite CM

2.3.1 Getting Started

When accessing Unite CM for the first time, follow the instructions in the Elise3 – Embedded

Linux Server including safety instructions M0275130 (enclosed in the delivery) or the

Installation Guide, Elise3, TD 92679GB.

NOTE: The IP address must not change during operation because renew of IP address via

DHCP is not handled. Other equipment connected to this product also expects a fixed

IP address in some cases. If the IP plan is changed, this product must be restarted to

update the IP address. Otherwise the system will not function properly.

1.LDAP version 3 (LDAPv3) is supported