Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
143
4 Select “Switch immediately” if you want to run the new software.
5 Select “Copy current settings” if you want the new software to inherit the settings
currently used. This selection will have no effect if the software type is different than
the currently used software. The module will always start up using factory settings if
the software type differs.
6 Click the “Start Installation” button.
21.3.1 Install New Software in a Redundancy System
When both the primary Unite CM and the secondary Unite CM are redundant, is it possible to
install software on both Unite CMs simultaneously. It is only needed to install the software
on the primary Unite CM since the software also will be installed on the secondary one
automatically. Follow the instructions in 21.3 Install New Software on page 142.
21.3.2 Create a Software Backup
It is recommended to now and then create a backup of the software configuration.
1 Click “Configuration” on the start page.
2 Select Software > Installation in the menu on the Configuration page.
3 Click the “Backup” button.
Note that the backup will contain configuration for the running software only.