Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
142
3Under Select settings, select one of the following:
• Keep previous settings — means that the settings last used for the software is
activated again after the switch. This option is only available if the software has
been used at least one time before.
• Copy Current settings — means that you copy the configuration from the
software you are currently using and is only available if both software are of the
same type.
• Use factory default settings — means that you apply the default settings that
were delivered from the factory.
NOTE: The active software’s current network settings will be kept and will also be
applied to the software you want to switch to.
4 Click “Switch”.
21.3 Install New Software
NOTE: It is not recommended to use the module’s Management port when installing
software.
1 Click “Configuration” on the start page.
2 Select Software > Installation in the menu on the Configuration page.
3 Select software (.pkg) to upload. The software will replace the not running software.