Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
141
21 Software Administration
Besides the software administration via Unite CM configuration page, it is also possible to
administer the software via the module’s Boot Mode GUI. This is described in the Installation
Guide, Elise3, TD 92679GB. The Boot Mode GUI is typically used if no software is installed on
the module or if it should be impossible to access the software.
21.1 Software Information
All information about the installed software is shown in this view. Two software versions
can be installed on the module.
1 Click “Configuration” on the start page.
2 Select Software > Information in the menu on the Configuration page.
The software name, versions, the date they were installed and also which version
that currently is running are shown.
21.2 Switch Software
If two software versions are installed on the module you can switch between them.
NOTE: When switching software over a Remote Management Client (RMC) using previous
settings, you might loose RMC connection to the module if the port is not opened on
both software 1 and software 2.
1 Click “Configuration” on the start page.
2 Select Software > Switch in the menu on the Configuration page.