Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
128
My Messages
Up to 30 predefined “My Messages” with 120 characters per message can be created. It is
also possible to have fewer “My Messages” containing more characters. These messages are
stored locally and can only be accessed or changed from that PC.
19.2.2 Create a Predefined Message
1 Click the “Common Messages” or “My Messages” button in NetPage. For “Common
Messages” enter the user name “user” and the password “password”.
2 Click “Add message”.
3 Enter the name of the message and add a message text of maximum 250 characters.
4 Set the message type, beep signal and priority.
5 Click “Save”.
6 Click “Close” to exit the administration.
19.2.3 Edit a Predefined Message
1 Click the “Common Messages” or “My Messages” button in NetPage. For “Common
Messages” enter user name and password (default “user” and “password”).
2 Click the message that shall be changed.
3 Make the changes and click “Save”.
4 Click “Close” to exit the administration.
19.2.4 Message History Status
Status on the last sent message:
In the default user interface (index4), other “message history statuses” can appear such as:
•Absence
• Call Diversion
• Manual Acknowledge
• Delivery Receipt
• The time and date a message was delivered
19.3 My Groups
NOTE: “My Groups“ are created from the NetPage and are not to be mistaken for the groups
created from the Configuration page in Unite CM. This functionality is only accessible
from index4, see figure 70 on page 154.
“My Groups“ are stored locally and can only be accessed or changed from the PC where they
are stored.
Status Description
Message accepted: The message is accepted by NetPage and will be transmitted.
Message completed: The Messaging System has completed the transmission of the
message.