Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
116
MX-ONE/MD110, Ascotel IntelliGate, and OmniPCX Enterprise
• IP address
Since the MX-ONE/MD110, Ascotel IntelliGate and MD Evolution is connected over the
LAN, the IP address of the MX-ONE/MD110, Ascotel IntelliGate or MD Evolution has to be
entered.
•Port Numbers
- Unite CM always uses port 1814 for communication with the MX-ONE/MD110. This
port has to be defined in the MX-ONE/MD110 as well. The MX-ONE/MD110 must be
configured to use port 1815 when communicating with Unite CM.
- The default port for communication with Ascotel IntelliGate is 2775.
NOTE: If Unite CM replaces a 9dMMS, check that other port numbers than the ones above
are not used for the communication between the 9dMMS and the MX-ONE/MD110.
IP-DECT
• DECT IP address
Since the IP-DECT Master is connected over the LAN, the IP address of the IP-DECT Master
has to be entered.
• Secondary DECT IP address
If two DECT systems are used for redundancy purposes, the IP address of the secondary
DECT system needs to be entered.
15.2.3 DECT Message Distribution
The DECT Interface has distribution lists that define where incoming data from handsets, for
example alarms and user data, should be sent.
To find settings for DECT Message Distribution, do as follows:
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Click “Messaging Distribution” under DECT Interface in the menu on the Advanced
Configuration page.
The following information is supported:
•Alarm
- Personal alarms with location information from handsets in the Cordless Telephone
System.
•Mobile Data
- User data sent from handsets in the Cordless Telephone System.
• Location
- Special Location
1
information from handsets in the Cordless Telephone System. This
information can be used to track the route of a handset in a building.
• Availability
- Includes absence information, i.e. if a handset is placed in Charging/Storage Rack.
The addressing of the receivers is described in Installation Guide, Elise3, TD 92679GB.
1.The Special Location can be sent every time a cordless handset gets a new location code from a location device in the
system. This requires configuration both in the handset and in the location device. Also called “Immediate Alarm Transmission”.