Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
115
15.2 DECT Interface settings
The DECT Interface controls the messaging flow between the Cordless Telephone System
and other system modules, for example UNITE compliant modules and System 900 modules.
15.2.1 General Settings
To find DECT General Settings, do as follows:
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Click “General Settings” in the menu on the Advanced Configuration page.
• Call Diversion Display Text
When this parameter is enabled, the text specified is added to the display message when
a call diversion takes place. The original Call ID can be included in the parameter text by
writing a % character where the Call ID shall be inserted.
Advanced parameters include:
• Extended Activity Log
In addition to when a Unite block is delivered to a handset, activity log information is
also sent to the Log Viewer when the block is received by the DECT interface. The extra
information can only be displayed in Log Viewers that are updated continuously and if
activity logs are configured in Unite CM. This function should be used with care as it
generates heavier network load. For more information about extended activity logs, see
Function Description, Activity Logging in Unite, TD 92341GB.
• Set time in DECT?
It is possible to set the time in DECT when the parameter is set to “Yes”. It is only
possible when DCT1800-GAP systems with CPU2 software is used. If the parameter is set
to “Yes”, Unite CM sets the time in DECT on startup and on each day at the time set by
the Time push time parameter.
• Priority Conversion
Used to convert messaging priorities; Alarm, High, Normal and Low. This conversion is
normally only used for compatibility with some PWT handsets and should never be
enabled unless you are absolutely sure.
• IM update status handling
• No of included 9dLD locations
Only valid in combination with Ascom messaging system.
15.2.2 System Dependent Settings
Which parameters that can be changed is dependent on the DECT Phone System that Unite
CM is connected to.
BusinessPhone, DCT1800-GAP, DCT1800-S, DCT1900, MD Evolution and
Enterprise Mobility Node
There are no system dependent features for these systems.