Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
113
15 DECT Interface
It is recommended to configure the carrier system interfaces from the Wizard, but it can also
be done from the Advanced Configuration page.
This chapter describes configuration from the Advanced Configuration page, for some
carrier systems. It does not include all supported carrier systems.
15.1 DECT Phone System
15.1.1 Alcatel OmniPCX Enterprise
Communication with the Alcatel OmniPCX Enterprise is done over the LAN. To be able to
receive alarms and user data from handsets in the system, a CMP board has to be installed in
the OmniPCX Enterprise. For configuration of the Alcatel OmniPCX Enterprise and installation
and configuration of the CMP board, see separate documentation from the vendor.
15.1.2 Ericsson BusinessPhone, DCT1800-GAP, DCT1800-S and DCT1900
For configuration of the DECT Phone System, see separate documentation from the vendor.
1 Connect the delivered cable to the serial port 1 (COM1) port on Unite CM.
2 Connect the cable to the I/O port on the IC-CU2 board on the DECT Phone System.
See Appendix B, for a description of the cable.
15.1.3 MX-ONE/MD110, Enterprise Mobility Node, Ascotel IntelliGate, MD Evoluition
Communication with the DECT Phone System is done over the LAN. For configuration of the
DECT Phone System, see separate documentation from the vendor.
15.1.4 IP-DECT
Figure 49. Redundancy achieved by connecting Unite CM to two IP-DECT base stations and setting
primary and secondary IP addresses.
Unite CM can communicate with the IP-DECT system over a LAN.
It is possible to set an address to a secondary IP-DECT master which is used as a redundancy
backup. The secondary IP Address is used if the connection to the primary IP Address is lost.
If the secondary IP Address is lost, Unite CM will try to use the primary IP Address.
To do IP-DECT IP address settings, do as follows:
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Restart Unite CM (not needed if configured from the Wizard).
4 Select “IP-DECT” in the menu on the Advanced Configuration page.
Figure 45.
Unite
Connectivity
Manager
IP-DECT Master
IP-DECT Master
DECT IP Address
Secondary DECT IP Address