Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
102
12 Text Displays
NOTE: License is required, see 1.1 Licenses for Unite CM on page 1.
NOTE: Each Unite CM module can control up to 50 corridor displays. Add another Unite CM
module to the system in order to extend the system with 50 more corridor displays.
The text displays feature makes it possible to send messages to external displays, such as
corridor displays, LED signs etc. The external displays must support the Adaptive Display
EZ-95 protocol when using Adaptive displays or the Elen display protocol when using NICD
and teleCARE displays. Up to 30 messages can be cycled in a text display and the messages
are sorted and removed, first by comparing priority and second by comparing the age.
The text display device must be added as a user in Unite CM with the number tied to the
Text Displays category.
12.1 Text Display Settings
If text displays shall be used, it must be configured as a connected messaging system in the
Setup Wizard. Detailed settings are configured from the Advanced Configuration page.
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Select “Text Displays” under Output Interfaces, in the menu on the Advanced
Configuration page. The Text Displays configuration page opens.
4 The parameters that can be set in the Text Displays page are:
Settings Description
General settings
Message display time: Default time for the message to be displayed if
there is a new message in the message queue. Can
be overridden by a display time set for an individual
text display.
Number of stored messages: Number of messages that can be stored and cycled
on each display.
Default TTL: Default time for the message to be stored if not
specified in the message.