Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
96
Miscellaneous
The parameters that can be set in the ESPA Miscellaneous Settings page are:
Character Code Conversion
The parameters that can be set in the ESPA Character Coding page are:
10.1.2 TAP Protocol Out
The following settings can be selected or changed in the TAP Out page:
Test Source for Message: Normally the Unite paging subject will be used to
create the text for the ESPA paging. In some cases, it
might be desirable to use the body of the message or
a combination of both. In that case, the body has to
contain proper information. Default: “Unite Paging
Subject”.
Subject/Body Separation: When “Unite Paging Subject+Body” is selected for the
message text source, this option selects how to
separate the subject and body. Default: “CR + LF”.
Settings Description
Use Call Status Info Time-out: If this parameter is set to 'Yes', the status of a call is
assumed to be 'paged' after a specified time-out.
Default: “Yes”.
Call Status Info Time-out:
(0 - 1 000 s)
If the 'Use Call Status Info Time-out' parameter is set to
'Yes', this parameter specifies the timeout before
assuming that the status of a call is 'paged'. Default:
30 s.
Settings Description
Characters 0..255: These fields specify the value of the byte that will be
transmitted on the ESPA bus for ISO8859-1 characters.
Accepted values are 0-255 with the exception of ESPA
control characters. Please note that values above 127
do not comply with the ESPA standard and may cause
problems with some ESPA devices.
Settings Description
Enabled: The TAP configuration can be enabled or disabled. If
disabled, the serial port is free to use for other
purposes. Default: No.
Name: Enter a name for the channel.
Serial port: Port selection (None,1,2): Default: None.
Bitrate: Select bitrate. Default: 9600 bits/s.
Mode: Communication mode to use. Default: 8 Data bits, Even
parity.
Flow control: Decides whether flow control shall be used. Default:
“None”.
ASCII conversion table: This table makes it possible to set up a transformation
of display message characters.