Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
94
10 Serial Interface Out
NOTE: Requires an additional license, see 1.1 Licenses for Unite CM on page 1.
The output serial interface makes it possible to send messages to external paging systems.
The output serial interface supports the ESPA 4.4.4 protocol and the TAP 1.8 protocol.
A description of cables for the connections are found in Appendix B: RS232 Connections on
page 202.
10.1 Output Serial Protocol Settings
Settings are configured from the Advanced Configuration page.
1 Click “Configuration” on the start page.
2 Select Other > Advanced Configuration in the menu on the Configuration page.
3 Click a link for the protocol you want to use (ESPA Out or TAP Out) in the menu on the
Advanced Configuration page.
4Continue in 10.1.1 ESPA Protocol Out or 10.1.2 TAP Protocol Out.
10.1.1 ESPA Protocol Out
The following settings can be selected/changed:
Serial Communication
The parameters that can be set in the ESPA Serial Communication Settings page are:
Settings Description
Enabled: The communication can be enabled or disabled. If
disabled, the serial port is free to use for other
purposes. Default: No.
Serial port: Port selection (1,2): Default: 2.
Baud Rate: Select Baud rate. Default: 9600 bits/s.
Data Bits: Number of data bits for this serial communication.
Default: 8.
Stop Bits: Number of stop bits for this serial communication.
Default: 1.
Parity: Parity to be used for this serial communication.
Default: Even.
Hardware Flow Control: Enables or disables hardware flow control. Default:
Disabled.