Troubleshooting guide

TD 92735EN
15 May 2012 / Ver. G
Installation and Operation Manual
Unite Connectivity Manager
93
2 Click “Activate”.
Mode: Select mode.
Default: 8 Data bits, Even parity
Flow control: Used for handshaking control. Default: None
Default Call ID: Number to call if not specified in the external
equipment. Default: 000
IP Address of Event Handler: A paging received via this serial interface will
override the number plan and be sent directly to the
Event Handler specified here.
Default display message: Message to display if not specified in the external
equipment. Default: BLANK
Default message priority: Priority if not specified in the external equipment.
Default: 7 (Normal)
Default beep code: Beep code if not specified in the external equipment.
Default: 2 beeps
Default urgency: If set to High “Stand-by“ mode in receiver is broken
through.
Default: Normal.
Transmission delay (x10 ms):
(Advanced)
How long to wait before transmission to receiver.
Default: 30 milliseconds
Enable checksum validation:
(Advanced)
Set to “No“ if, for example, external equipment. uses
an algorithm that differ from the 7-bit value used in
TAP.
Default: Yes
Delay time before a log on
timeout occurs:
(Advanced)
How long to wait before disconnecting the external
equipment.
Valid values: 0-127 where 0 means 'Not enabled'.
Default 8 seconds
Delay time before a block
timeout occurs:
(Advanced)
How long this module shall wait before hanging up.
Valid values: 0-127 where 0 means 'Not enabled'.
Default 4 seconds.
Numbers of allowed times to
log on:
(Advanced)
How many log on attempts from external
equipment shall be permitted.
Valid values: 1-127.
Default 3 tries.
Numbers of allowed checksum
failures:
(Advanced)
How many checksum failures from external
equipment shall be permitted.
Valid values: 1-127.
Default 3 tries.
Numbers of allowed timeouts: How many timeouts shall be permitted.
Valid values: 1-127.
Default 3 timeouts.
ASCII conversion table: Makes it possible to convert display message
characters.