User manual

TD 92582EN
21 June 2012 / Ver. G
User Manual
Ascom d41 DECT Handset
50
Figure 10. Easy Replacement Procedure via the DC4 Advanced Desktop ChargerI
1 On the new handset, press and hold
NOTE: Do not release until you are instructed to do so.
2 Put the new handset in the charger.
3 When the text "Start phone replacement?" is displayed, release .
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in
the display. Press "OK"(left soft key).
4, 5 When the text "Please insert old phone in charger" is displayed, replace the new
handset with the old handset. The handset can either be switched on or off.
NOTE: If the CR3 Charging Rack is used, the left charging slot has to be used for
both handsets.
The handset will be restarted and after a few seconds, the text "Saving settings. Do
not remove phone from charger" appears. The charger LED changes to slow
orange flashing. It might take several minutes.
IMPORTANT: If the old handset cannot communicate with the charger, put the new
handset in the charger to restore its settings (that is, the handset’s IPDI). If this step
is not performed, the new handset must be sent for service. The old handset’s
settings might be transferred to the new handset by using PDM. See the handset’s
Configuration Manual.
6, 7 When the text "Please insert new phone in charger" is displayed, replace the old
handset with the new handset. The text "Restoring settings" is displayed.
IMPORTANT: Do not remove the handset while the text "Restoring settings" is
displayed.
8 When the text "Phone successfully replaced. Please remove phone to restart."
appears in the display, remove the handset from the charger. The handset is
automatically restarted.
1
2
3
New New Old
New
4, 8 5 67