User manual

TD 92582EN
21 June 2012 / Ver. G
User Manual
Ascom d41 DECT Handset
44
LED Error Indications
See also chapter LED Indications during Easy Replacement on page 51.
No System. The
handset beeps once a
minute (during max 30
minutes) with a low
tone followed by a
high tone (if enabled,
the vibrator also
follows the beeps).
The handset is out of coverage or
handset is defective.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
Faulty handset. Select the reset option on the
middle soft key and upgrade
the handset’s software to
version 3.0.0 or greater. If this
is not available or the problem
persists send the handset for
service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure
during easy replacement
procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
PDM or do a factory reset via
PDM.
Battery low, charge
now
The battery level is low. Charge or replace the battery.
Phonebook is not
available at the
moment.
The phonebook does not
respond, not available at the
moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number via
PDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base station(s);
and/or,
2) Unsupported base station(s).
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in the
base station(s); and/or,
Note: If Ascom’s base
station(s) is used, the software
version must be 3.1.x or
greater.
3) Use supported base
station(s). Ask your supplier.