User manual

TD 92477EN
31 October 2013 / Ver. J
User Manual
Ascom d62 DECT Handset
12
The three Soft keys are located just beneath the display and the functions of each Soft key
is indicated by text in the display just above the keys.
In idle mode, the Soft keys can be used for specifi
c functions defined by the user of the
handset.
2.4.8 Hot Keys
Any key "0", "2" - "9" can be set to a Hot Key. A long press on any
of these numbers in stand
by mode are by default a shortcut to the Call contact list. The list is in alphabetic order, and
depending on which key that is pressed is dependent on where in the list the contact
appears.
A Hot Key can be programmed to give access to frequently used functions such as dialling a
spe
c
ific handset number, a shortcut on the menu, or sending an SMS.
2.4.9 Multifunction Button
Note: This feature is applicab
le for d62 Talker and d62 Messenger only.
This button can be used as a shortcut to functions;
long or double press modes. It is by
default not used, but can be defined by the user of the handset. If the button is defined, it
can be used in standby mode only.
2.4.10 Volume Button
The two buttons placed on the upper left side of the ha
ndset are used for increasing/
decreasi
ng the earpiece, headset, and the loudspeaker volume.
2.5 Alphanumeric Keys
006
. , ? ! - ‘ ” 1
a b c à â ä æ ç 2
d e f é è 3
j k l 5
m n o ñ ò ö ø 6
t u v ù ü 8
#
g h i î 4
b
p q r s β 7
w x y z 9
Space + * 0
Figure 5. Available characters.
NOTE: Depending on the selected menu language and character setting in t
he IMS3/Unite
CM, other characters can be available. This means that the character order can differ from
the figure above.
In standby mode, and number in
put mode
•
A short press on a key enter the digits “0” - “9” and the characters * and #.
• Enter a pause in number input mode by a long press on the #
-key. A pause is indicated
by a "P" in the display.