User`s guide
Table Of Contents
- Ascend Customer Service
- How to use this guide
- What you should know
- Documentation conventions
- How to use the on-board software
- Manual set
- Configuring WAN Connections
- Configuring IP Routing
- Introduction to IP routing on the Pipeline
- Managing the routing table
- Parameters that affect the routing table
- Static and dynamic routes
- Configuring static routes
- Specifying default routes on a per-user basis
- Enabling the Pipeline to use dynamic routing
- Route preferences
- Viewing the routing table
- Fields in the routing table
- Removing down routes to a host
- Identifying Temporary routes in the routing table
- Configuring IP routing connections
- Ascend Tunnel Management Protocol (ATMP)
- IP Address Management
- Connecting to a local IP network
- BOOTP Relay
- DHCP services
- Dial-in user DNS server assignments
- Local DNS host address table
- Network Address Translation (NAT) for a LAN
- Configuring IPX Routing
- How the Pipeline performs IPX routing
- Adding the Pipeline to the local IPX network
- Working with the RIP and SAP tables
- Configuring IPX routing connections
- Configuring the Pipeline as a Bridge
- Defining Filters and Firewalls
- Setting Up Pipeline Security
- Pipeline System Administration
- Pipeline 75 Voice Features
- IDSL Implementations
- APP Server utility
- About the APP Server utility
- APP Server installation and setup
- Configuring the Pipeline to use the APP server
- Using App Server with Axent SecureNet
- Creating banner text for the password prompt
- Installing and using the UNIX APP Server
- Installing and using the APP Server utility for DO...
- Installing and using the APP Server utility for Wi...
- Installing APP Server on a Macintosh
- Troubleshooting
- Upgrading system software
- What you need to upgrade system software
- Displaying the software load name
- The upgrade procedure
- Untitled
Configuring IP Routing
Configuring IP routing connections
2-30 Preliminary January 30, 1998 Pipeline User’s Guide
Identifying Temporary routes in the routing table
The “T” flag appears in the IP routing display to indicate temporary routes. In
this example, the Show IP Routes command displays two temporary routes:
ascend% show ip routes
Configuring IP routing connections
Note:
If you configure a routing configuration to a second destination, be sure
to specify routing information for both sides. Specify the remote network
information in the Connection profile for that network. Network information for
the local Ethernet is configured in the Ethernet > Mod Config profile.
This section describes how to configure IP routing connections. It describes
typical host software requirements and includes the following example
configurations:
• Example host connection with static address
• Example router connection
• Example router connection on a subnet
Note:
The most common cause of trouble in initially establishing an IP
connection is incorrect configuration of the IP address or subnet specification for
the remote host or calling device.
Checking remote host requirements
IP hosts, such as UNIX systems, Windows or OS/2 PCs, or Macintosh systems,
must have appropriately configured TCP/IP software. A remote host calling into
the local IP network must also have PPP software.
• UNIX
UNIX systems typically include a TCP/IP stack, DNS software, and other
software, files, and utilities used for Internet communication. UNIX network
Destination Gateway IF Flg Pref Met Use Age
192.168.252.0/30 192.168.252.1 wan10 rGT 60 7 0 7
192.168.252.1/32 192.168.252.1 wan10 rT 60 7 1 7