User`s guide

MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 6-1
6
Configuring MultiVoice
MultiVoice call configuration
To enable MultiVoice calling, you must configure each MultiVoice Gateway with the
following information:
• The IP address of the MultiVoice Access Manager
• Whether or not the MultiVoice Access Manager requires users to enter a Personal
Identification Number (PIN) for authentication.
• The type of voice compression and coding to use for MultiVoice calls.
Additionally, you may improve MultiVoice call performance by:
• Entering an IP address for a secondary MultiVoice Access Manager.
• Adjusting the frequency and time intervals when a MultiVoice Gateway must register with
the MultiVoice Access Manager.
• Enabling use of a fixed or dynamic Jitter Buffer.
• Enabling silence detection and comfort noise generation.
• Modifying the Type of Service (ToS) byte for UDP packet processing.
• Modifying the maximum number of calls a MultiVoice Gateway processes.
• Enabling single-stage dialing.
• Disabling PSTN progress tone cut-through on the local MultiVoice Gateway.
MultiVoice call configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1
Configuration options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-2
MultiVoice configuration examples. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7
Using authentication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-19