User`s guide

Configuring the WAN Interfaces
Configuring E1 lines
MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 5-15
2 Configure the nailed channels. For example, to assign channels 1–5 to the same nailed
connection:
Ch 1=Nailed
Ch 1 Prt/Grp=3
Ch 2=Nailed
Ch 2 Prt/Grp=3
Ch 3=Nailed
Ch 3 Prt/Grp=3
Ch 4=Nailed
Ch 4 Prt/Grp=3
Ch 5=Nailed
Ch 5 Prt/Grp=3
3 Close the E1 profile.
Configuring DNIS and ANI collection for E1 R2
Configuration for systems using ITU-T Q.464 standard E1 R2 signalling
To configure DNIS/ANI collection for the ITU standard E1 R2 signalling:
1 Open Net/E1 > Line Config and set both lines to Trunk service:
Net/T1
Line Config
Name=
1st Line=Trunk
2nd Line=Trunk
2 Open the Line 1 subprofile and set the signalling mode to R2:
Line 1...
Sig Mode=R2
Note: When Sig Mode=R2, DNIS and ANI are automatically collected.
3 Close the Line 1 subprofile.
4 Open the Line 2 subprofile and set the same values for these configuration values.
Configuration for systems using localized E1 R2 signalling
To configure ANI collection for localized (country-specific) E1 R2 signalling:
1 Open Net/E1 > Line Config and set both lines to Trunk service:
Net/T1
Line Config
Name=
1st Line=Trunk
2nd Line=Trunk
2 Open the Line 1 subprofile and set the signalling mode to appropriate localized R2
signalling option, for example CZECH:
Line 1...
Sig Mode=CZECH