User`s guide

Navigating the User Interface
Privileges and passwords
MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 4-11
In the DO menu, press P (or select P=Password). The Edit window displays the list of Security
profiles. Select Full Access and press Enter. The MultiVoice Gateway prompts for that
profile’s password:
00-300 Security
Enter Password:
[]
Press > to accept
Enter Ascend (unless you have changed the default password.)
After you press Enter, a message states that the password was accepted and the MultiVoice
Gateway is using the new security level. Or, if the password you entered is incorrect, you are
prompted again to enter the password.
Note: For a Console session established through Telnet, the caller must first supply the Telnet
password to establish a Telnet session. Then, the Default security level is set for that session.
To configure the MultiVoice Gateway through Telnet, the caller must activate a Security
profile that has Operations set to Yes.
Modifying the Full Access Profile
To ensure complete access when needed, you should leave the default settings in the FUll
Access profile unchanged, except for the Password setting. TO prevent unauthorized access,
you should change the default Password setting (Ascend) as soon as possible. Proceed as
follows:
1 Open the System > Security > Full Access profile.
2 Set the Password parameter to a value only your system administrators know.
3 Exit and save your changes.
Other administrative profiles
To create customized profiles for individual administrators or groups of administrators, see
Chapter 10, “MultiVoice Gateway System Administration.”