User`s guide

vi Preliminary November 10, 1998 MultiVoice Gateway for the MAX— User’s Guide
16 Do not attempt to service this product yourself. Opening or removing covers can expose
you to dangerous high voltage points or other risks. Refer all servicing to qualified service
personnel.
17 General purpose cables are provided with this product. Special cables, which might be
required by the regulatory inspection authority for the installation site, are the
responsibility of the customer.
18 When installed in the final configuration, the product must comply with the applicable
safety standards and regulatory requirements of the country in which it is installed. If
necessary, consult with the appropriate regulatory agencies and inspection authorities to
ensure compliance.
19 A rare phenomenon can create a voltage potential between the earth grounds of two or
more buildings. If products installed in separate buildings are interconnected, the voltage
potential might cause a hazardous condition. Consult a qualified electrical consultant to
determine whether or not this phenomenon exists and, if necessary, implement corrective
action before interconnecting the products.
In addition, if the equipment is to be used with telecommunications circuits, take the following
precautions:
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using equipment connected to telephone lines (other than a cordless telephone)
during an electrical storm. There is a remote risk of electric shock from lightning.
• Do not use a telephone or other equipment connected to telephone lines to report a gas
leak in the vicinity of the leak.
Warning: To reduce the risk of fire, communication cable conductors must be 26 AWG or
larger.
Avertissement: Afin de reduire les risques d'incendie, les fils conducteurs du cable de com-
munication doivent etre d'un calibre minimum de 26 AWG (American Wire Gauge), cest-a-dire
d'un minimum de 0,404 mm.
Warnung: Um Feuerrisiken zu reduzieren, müssen die Kommunikationskabel-Anschlüße 26
AWG oder größer sein.