User`s guide

B-4 Preliminary November 23, 1998 MultiVoice Gateway for the MAX— User’s Guide
Provisioning the Switch
Provisioning the switch for ISDN BRI access
Table B-3 provides provisioning information for Northern Telecom switches.
Note: The MultiVoice Gateway can receive multichannel calls using Combinet or MP
encapsulation only if all channels of the call share a common phone number (namely, a hunt
group). You can request that your service provider supply you with a hunt group.
Information required from the ISDN BRI provider
If a Net/BRI module (MX-SL-8BRIN) is installed, your ISDN BRI provider must provide you
with the following information:
• The phone number assigned to your ISDN BRI line.
• The SPIDs assigned to your ISDN BRI line (for lines running in any mode other than
AT&T Point-to-Point). In countries outside the United States, SPIDs might or might not
be required. Check with your carrier.
• Which channels are nailed up or unused, if any.
Ringing/Idle Call
Appearances
Idle The default for Terminal Type A.
Autohold is Y/N No The default for Terminal Type A.
Onetouch is Y/N No The default for Terminal Type A.
Table B-3. Northern Telecom provisioning information
Element Value Comments
Signaling Functional
Protocol Version Control
(PVC)
1 or 2 1 is NTI custom.
2 is NI-1 (National ISDN-1), which
requires a TID to be assigned as a suffix
to the SPID.
TEI assignment Dynamic
Release Key No Not relevant for proper operation of the
MultiVoice Gateway.
Ringing Indicator No Not relevant for proper operation of the
MultiVoice Gateway.
EKTS (Electronic Key
Telephone System)
Off
Table B-2. AT&T 5ESS provisioning information (continued)
Element Value Comments