User`s guide

MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 B-1
B
Provisioning the Switch
Provisioning the switch for T1 access
If you use an inband signaling line, the T1 circuit at the Point-of-Presence (POP) must support
the translations listed in Table B-1 for compatibility with the MultiVoice Gateway.
Provisioning the switch for T1 access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-1
Provisioning the switch for T1 PRI access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-2
What you need from your E1/PRI service provider. . . . . . . . . . . . . . . . . . . . . . . . . . . . B-2
Supported WAN switched services . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-3
Provisioning the switch for ISDN BRI access. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-3
Table B-1. T1 access provisioning information
Translation Optional or required
Two-state DTMF (Dual-Tone
Multifrequency) dialing
Required.
Outgoing wink start Required.
Incoming immediate seizure Optional for a switch.
Does not apply on T1 lines to a PBX.
Incoming wink start Optional for a switch
Required on T1 lines to a PBX
Incoming digits suppressed Required, except when a PBX is connected
to a T1 line supplied by the MultiVoice
Gateway through PRI-to-T1 conversion.
Answer supervision Required.
Switched data Required.
No voice/digital loss plan is allowed, but the
drop-and-insert channels to a PBX and the
channels to digital modems can be voice
channels.