User`s guide

MultiVoice Gateway System Administration
Terminal-server commands
MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 10-15
For example:
ascend% test 555-1212
You can press Ctrl-C at any time to terminate the test. While the test is running, the MultiVoice
Gateway displays the status. For example:
calling...answering...testing...end
200 packets sent, 200 packets received
If you enable trunk groups on the MultiVoice Gateway, you can specify the outgoing lines used
in the self test. If you do not, the MultiVoice Gateway uses the first available T1 (or E1) line.
For example, if you assign the trunk group 7 to line 1 on a Net/BRI module and a preceding 9
is required by your PBX to make an outgoing call, the following command places the outgoing
call on line 1 of the Net/BRI module:
ascend% test 7-9-555-1212
The MultiVoice Gateway generates an error message for any condition that causes the test to
terminate before sending the full number of packets. Possible error messages are as follows:
call-by-call=T1-PRI-service Enter any value available to the Call-by-Call
parameter of the Connection profile. The
Call-by-Call parameter specifies the PRI service
that the MultiVoice Gateway uses when placing a
PPP call. For a list of valid values, see the MAX
Reference Guide. If you do not specify a value,
the default is as specified for the Call-by-Call
parameter.
primary-number-type=AT&T-switch Specify any value available to the PRI # Type
parameter of the Connection profile. The PRI #
Type parameter specifies an AT&T switch. For a
list of valid values, see the MAX Reference
Guide. If you do not specify a value, the default
value is the one specified for the PRI # Type
parameter.
transit-number=IEC Specify any value available to the Transit #
parameter of the Connection profile. The Transit
# parameter specifies the U.S. Interexchange
Carrier (IEC) you use for long distance calls over
a PRI line. For a list of valid values, see the MAX
Reference Guide. If you do not specify a value,
the default is as specified for the Transit #
parameter.
Message Explanation
bad digits in phone
number
The phone number you specified contained a character
other than the numbers 0 through 9 and the characters
()[]-.
Field Usage