User`s guide

MultiVoice Gateway System Administration
System and Ethernet profile configurations
MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 10-3
2 In the list of Security profiles that opens, select Full Access. The MultiVoice Gateway
prompts you for the Full Access password:
00-300 Security
Enter Password:
[]
Press > to accept
3 Type the password assigned to the profile and press Enter.
When you enter the correct password, the MultiVoice Gateway displays a message
informing you that the password was accepted and that the MultiVoice Gateway is using
the new security level.
Message #119
Password accepted.
Using new security level.
If the password you enter is incorrect, the MultiVoice Gateway prompts you again for the
password.
Note: The default password for the Full Access login is Ascend. The first task you should
perform after logging in as the superuser is to assign a new password to the profile.
System and Ethernet profile configurations
This section describes the system-administration configurations shown in the following
example:
System
Sys Config
Name=gateway-1
Location=east-bay
Contact=thf
Date=2/20/97
Time=10:00:29
Term Rate=9600
Console=Standard
Remote Mgmt=Yes
Max Dialout Time=20
Parallel Dial=5
Single Answer=Yes
Sub-adr=None
Serial=0
Lan=0
DM=0
Use Trunk Grps=No
Excl Routing=No
Auto Logout=No
Idle Logout=0
DS0 Min Rst=Off
Max DS0 Mins=N/A
High BER=10 ** -3
High BER Alarm=No
No Trunk Alarm=No
Edit=00-000
Status 1=10-100