User`s guide

Configuring MultiVoice
MultiVoice configuration examples
MultiVoice Gateway for the MAX— User’s Guide Preliminary November 23, 1998 6-9
9 Press Enter to save your change.
Gatekeeper registration policy and failure detection
At H.323 stack initialization time, the MultiVoice Gateway attempts to register with the
primary Gatekeeper. The H.323 stack will not initialize when the primary Gatekeeper is not
configured. Registration with a primary Gatekeeper fails when the Gateway cannot register
with the primary gatekeeper after all attempts have been made. By default, the MultiVoice
Gateway makes five (5) registration attempts at 5-second intervals.
When registration with the primary Gatekeeper fails:
• If there is a valid address (non-null) configured for the 2nd GK IP, a MultiVoice Gateway
will attempt to register with the secondary Gatekeeper; applying the same registration
policy (five (5) registration attempts at 5-seconds intervals).
• If there is no valid address (null) configured for the 2nd GK IP, then the MultiVoice
Gateway goes into a slow poll mode.
Configuring PIN authentication
To configure PIN authentication on a MultiVoice Gateway:
1 Open the Ethernet > Mod Config > VOIP Options menu.
2 Set the VPN mode parameter by pressing Enter to toggle between Yes and No. For
Example:
Ethernet
Mod Config
VPN Mode=Yes
If the MultiVoice Access Manager requires user PIN authentication, set VPN Mode=No.
If you set VPN Mode=No, the MultiVoice Gateway prompts callers for their PIN before
they enter the destination phone number.
Configuring ANI authentication
To configure ANI authentication on a MultiVoice Gateway:
To configure DNIS/ANI collection for a T1 using robbed-bit signaling:
1 Open Net/T1 > Line Config profile.
2 Open the Line subprofile and set the signaling mode to Inband:
Line 2...
Sig Mode=Inband
3 configure Rob Ctl for either wink-inc-200 or wink-inc-400:
Rob Ctl=wink-inc-200
Note: If the value of Rob Ctl is set to Wink-Start, then Collect DNIS/ANI will be set to
N/A, preventing caller ID collection.
4 Configure Collect DNIS/ANI to yes:
Collect DNIS/ANI=yes
5 Close the Line 1 subprofile.