User`s guide

6-8 Preliminary November 23, 1998 MultiVoice Gateway for the MAX— User’s Guide
Configuring MultiVoice
MultiVoice configuration examples
To configure MultiVoice communications with both a primary and secondary Gatekeeper:
1 Open the Ethernet > Mod Config > VOIP Options menu.
2 Set GK IP Adrs to the IP address of the primary MultiVoice Access Manager. For
example:
GK IP Adrs = 10.10.10.10
3 Set 2nd GK IP to the IP address of the secondary MultiVoice Access Manager. For
Example:
2nd Gk IP = 11.11.11.11
Verify connectivity by Pinging the IP address of both MultiVoice Access Managers from
the MultiVoice Gateway terminal server. If the Pings fail, see your network administrator
about possible routing problems.
Configuring Gateway registration policy
To configure registration policy for a MultiVoice Gateway:
1 Open the Ethernet > Mod Config > VOIP Options menu.
2 Set the Keepalive Timer by pressing Enter to open the edit field, and entering a value
between 1 and 65535 (seconds). For example:
Ethernet
Mod Config
Keepalive Timer:
[120]
3 Press Enter to save your change.
Note: If you change this parameter, you should also change the
registrationDuration parameter on the MultiVoice Access Manager. A
Gateways’s registration with MVAM will automatically expire within that time frame.
4 Set the Reg Retries by pressing Enter to open the edit field, and entering a value between 0
and 200 (attempts). For Example:
Ethernet
Mod Config
Reg Retries:
[5]
5 Press Enter to save your change.
6 Set the Reg Retry Timer by pressing Enter to open the edit field, and entering a value
between 0 and 200 (seconds). For Example:
Ethernet
Mod Config
Reg Retry Timer:
[5]
7 Press Enter to save your change.
8 Set the Pri GK Retries by pressing Enter to open the edit field, and entering a value
between 0 and 200 (attempts). For Example:
Ethernet
Mod Config
Pri GK Retries:
[5]