User Guide

Service Centre Quick Access

The Service Centre quick access allows you to call the service centre (eg.

helpline, support centre of network provider) by a single key press. Refer to

the programming section for how to enter or edit the service centre phone

number.

• Press and hold “0” in Standby to

seize the line.

• The programmed number will be

dialed.

• The number will be displayed as it

is dialed.

• Call timer and talk time remaining

counter are displayed accordingly.

• Press PHONE key again to end

the call.

Things you can do during a call

You can do the following during a call,

a. Adjust speaker volume;

b. Mute call;

c. Change dial tone;

d. Send flash signal;

e. Dial extra digits;

f. Dial from phonebook record;

g. Display user phone number.

Adjust Speaker Volume

16 different levels of speaker volume can be selected.

• Press UP/DOWN key to adjust the

speaker volume during the call.

Mute Call

All the calls can be muted or unmuted.

• Press MUTE key to mute or un-

mute the call.

(When the call is muted, mute

icon turns on and LEDs on POD

turn RED and flash slowly).

Note: If the service centre number is not entered or is modified and

contains no digit, you will hear a reject tone and no call will be

dialed.

Note: If the service centre number has more than 18 digits, only the

last 18 digits shall be displayed. The Scroll icon shall turn on.