User's Manual

- 29 -
The System
REGISTERING YOUR HANDSET WITH ADDITIONAL BASE
This section shows you how to register your handset to additional base
unit(s). If your handset displays UNREGISTERED, refer to Registering your
handset on page 11.
1. Press and hold
on the base unit for 4 seconds.
2. Press
on the handset.
3. Select ADVANCED SET  REGISTRATION. Press OK .
4. Enter the system PIN (Pre-set: 0000). Press BACK to make
corrections.
5. Press OK .
6. Select the base number you want. A blinking digit indicates
that the base number is already being used. Your handset
starts searching for the base.
If registration is successful, the signal icon
displays steadily
along with the handset name. The base assigns a handset
number to your handset. It is the digit displayed on the right
margin of the screen.
If registration failed, repeat the above procedure.
SELECTING A BASE UNIT
You can switch your handset between different base units that it has
registered to. For your convenience, you can program the handset to
automatically connect to the closest base unit. You can also program the
handset to only connect to a fixed base unit you have specified.
1. Press
.
2. Select ADVANCED SET  BASE SELECT. Press OK .
3. Select the base unit you want or select AUTO if you want your
handset to automatically connect to the closet base unit.
4. Press OK . The new setting is saved.
NOTE: Each handset can be registered to up to 4 base units.