User's Manual

Draft - Wireless IPT Quick Reference Guide 10/04 10
Call Transfer
1. While on a call, press Cnf/Trn.
2. Dial the extension and announce the call or “blind transfer”
(hang up).
During call transfer, you can reconnect to the original caller
by pressing question what???.
3. Camp on to a busy station: If the station is busy, hang up.
The called station receives a tone. Once the busy line (why
was this underlined) is free, the transferred line is called back.
Conference Calls
1. While on a call, press Cnf/Trn.
2. Call another station or outside line.
3. When the called party answers, press
Cnf/Trn. If it’s busy or
there’s no answer, press
Cnf/Trn again to return to the
original connection. All parties are conferenced.
4. Repeat the above steps to add more lines. You can conference
up to eight parties.
Note When the person who initiates the conference (master)
hangs up, control transfers to the first internal station added
to the conference. If no internal stations are in the
conference, the call disconnects.
³ To transfer conference control
1. Do steps 1 and 2 above to add the line to which you wish to
transfer conference control.
2. Announce the call and hang up to transfer the call. This
station is now the conference “master” with the ability to add
or delete parties.
³ To hold a conference call
³ If you are the “master” conference controller, press Hold once (or
twice for Executive Hold) to place the conference call on hold.
CIX-QR-WIPT2000.book Page 10 Tuesday, September 14, 2004 5:20 PM