User's Manual

5 of 12
Basic Steps to Install
1. Connect the output plug of the mains adapter to the DC socket on
the side of the baby unit and the mains adapter to the wall mains
supply.
2. Plug the charger adaptor for the Parent Unit into the mains power
socket.
3. Remove the battery door on the Parent Unit by lifting the battery
door outward from the bottom.
4. Insert 2 x AA rechargeable batteries, observing their polarities, into
the battery compartment on the Parent Unit.
5. Replace the battery door on the Parent Unit.
6. Place the Parent unit on the charger to charge. The red Led on the
charger will turn on
7. Let the batteries charge for a full 16 hours before using for first time
installation.
Note: The baby unit also works on battery power. You can insert 4 x
1.5V AA Alkaline batteries in the battery compartment on the
Baby Unit. In case of power interruption, the baby unit continues
to work on battery power. If the baby unit is on battery power,
Battery is displayed, together with the battery icon and current
temperature, on idle mode.
Belt clip
User can also attach the belt clip to the Parent Unit.
To attach: To remove:
Press the inner wall of the belt clip
upward and lift the belt clip outward.
LCD Display
Icon Function
Indicates current battery level (display on Parent Unit
and when Baby Unit is on battery)
• Animated when charging.
• When the battery indicator displays 3 blocks, the
battery is fully charged.
• When the battery indicator displays no block, the
battery is almost empty, and requires charging.
The starry night light on Baby unit is currently on
Lullaby is currently playing on baby unit
Currently adjusting sensitivity level (display on Parent
Unit LCD only)
Baby unit night
light active icon
Lullaby icon
7-segment
Temperature
display
Battery charging icon
Menu display
Sensitivity icon