User's Manual

2. Press Up or Down to select DISPLAY. Press OK.
3. Press Up or Down
to select LANGUAGE. Press OK.
4. Press Up or Down
to select the preferred language. Press OK to save settings.
Set dialing mode (Tone/Pulse)
Dialing mode applies only when you are making a telephone call. Your phone is by default set to tone
dialing. You can switch to pulse dialing if necessary.
Press MENU.
Press UP or DOWN
to select SETTINGS. Press OK.
Press UP or DOWN to select DIAL MODE. Press OK.
Press UP or DOWN
to select TONE or PULSE dialing. Press OK to save.
3.7.
Flash duration
Your phone comes with factory programmed flash durations. Check with your local telephone
company if you are not sure which duration to use.
1. Press MENU.
2. Press
Up
or
Down
to select SETTINGS. Press
OK
.
3. Press Up or Down
to select FLASH. Press OK.
4. Press
Up
or
Down
to select the desire flash duration. Press
OK
.
3.8.
Pause duration
Your phone comes with 2 factory programmed pause durations.
1. Press
MENU
.
2. Press Up or Down
to select SETTINGS. Press OK.
3. Press Up or Down
to select PAUSE. Press OK.
4. Press
Up
or
Down
to select PAUSE 1 or PAUSE 2. Press
OK
.
3.9.
Area code stripping
This section is applicable to models with Area Code Stripping option only.
Temporary tone dialing in pulse dial mode
If the dialing mode is set to pulse, you can press and hold the
key to set temporary tone dialing
during off hook. d will be displayed on the screen. All the following digits will be dialed as tones
until you hang up.
Area code stripping removes an area code as specified by you from any incoming caller id.
To activate and program the area code to be stripped:
1. Press
MENU
.
2. Press
Up
or
Down
to select SETTINGS. Press
OK
.
3. Press Up or Down to select AREA CODE. Press OK.
4. Press Left or Right to select ON.
5. Press Down. Enter area code. Press OK to confirm.
3.10.
Set display contrast
1. Press
MENU
.
2. Press UP or DOWN
to select DISPLAY. Press OK.
3. Press UP or DOWN
to select CONTRAST. Press OK.
4. Press
LEFT
or
RIGHT
to adjust the display contrast. Press
OK
to save the desire
settings.
3.11.
Restore handset default settings
You can reset the display, sounds, and other settings of your phone. Refer to the section Default
settings.
1. Press MENU.
2. Press UP or DOWN
to select SYSTEM and press OK.
3. Press UP or DOWN
to select RESET and press OK.
4. Press
OK
to confirm.
3.12.
Set Baby call on/off
Baby call allows you to dial out a programmed number via the telephone line by pressing any
key on the handset (except the OFF key).
1. Press
MENU
.
2. Select SETTINGS and press
OK
.
3. Select BABY CALL and press OK.
4. Press LEFT or RIGHT key
to select ON.
5. Press
DOWN
, Enter or edit the number.
6. Press
OK
to confirm. BABY CALL is displayed when you return to standby mode.