User`s manual
Trouble Shooting
S
C
C
Trouble Shooting
S
ymptom
C
heckpoint
C
ountermeasure
● Can't turn on power
● There is no image on monitor
● Only INFO OSD is on
monito
r
●
Is DVR connected to power
supply cable?
●
Are DVR and monitor turned
on?
● Are cables of DVR
connected?.
● Connect power cable
●
Turn on power.
●
Connect DVR cable.
●
Turn on camera.
● Connect cables of DVR and
and no image
● There is Video Loss
message.
● Can't search with Client
Program.
●
Is camera turned on?
●
Are cables of DVR and
monitor connected?
●
Is NTSC/PAL setting normal?
●
Is connection between DVR
and camera normal?
●
Isn't another user using same
IP?
monitor.
● Check whether NTSC/PAL
setting is SETUP properly
●
Check whether DVR and
camera are connected properly
● Use it after another use
finishes using it. If another user
is searching DVR remotely with
same IP, you can not search.
Program.
●Motion Detection doesn't
work
well
● There are differences
between Live screen and actual
IP?
●
Isn't it too bright or too dark?
●
Isn't camera installed too far
away?
.
same
IP,
you
can
not
search.
● Increase Motion Detection
sensitivity.
● Install camera closer.
● Since it buffers Live images,
there might be changes with
actual condition. (1~2 sec)
between
Live
screen
and
actual
condition during remote
monitoring
● Live doesn't work well in
remote monitoring
●
Is it set to True Color?
●
Are PC specifications and
VGA Card specifications are
appropriate?
● Refer to recommended Client
PC specifications in 4-1
Installing
Client Program?
48