Installation guide

Page 13

Installing the NetStacker Chassis

Checking the Fuse A blown fuse usually indicates a serious problem in the power

supply. Contact Asanté Technical Support (see “Asking for Assis-

tance” on page v of this manual) to help you determine the cause

and decide if it is necessary to replace the fuse or return the hub

for testing and servicing.

To check the fuse:

Make sure the power is turned off, then unplug the

hub.

Insert a small screwdriver under the fuse faceplate

located on the hub’s back panel, then lift it off.

Check the fuse to see if it has blown.

A back-up fuse is stored in the fuse holder (a small

black box) adjacent to the fuse.

∆ Note: Always use the same type of fuse (2A/

250V Fast Blow) that came with the chassis. Fail-

ure to do so may result in damage to the hub.