Installation guide

Page 5
Installing the NetStacker Hub
Installing the
NetStacker Hub
To install a
single NetStacker Hub
, you will perform the following
procedures (if you have purchased unassembled components):
❏ Install the NetStacker Chassis
❏ Install a module in the chassis
With the RJ45B or RJ21B Modules, if using an
NMM Lite, mount the NMM Lite daughter card on
the module before you install it.
Instructions for installing the NetStacker Chassis are on page 7 of
this manual. Instructions for installing a module in the chassis are
in the individual installation guide for the module.
A preassembled NetStacker Hub requires only that you place it on
a desk or rack and plug it into a power outlet.
To build a
stack of two or three NetStacker Hubs, you need to
perform the following operations:
❏ If you are using individual modules, build a Base
Hub
❏ Place the Base Hub on a desk or mount it on a
rack
❏ If you are using individual modules, build an
Expansion Hub
❏ Place the first Expansion Hub on top of the Base
Hub
❏ If you have a second Expansion Hub, build the
hub (if using individual modules) and place it on
top of the first Expansion Hub
Instructions for building a stack of NetStacker Hubs are on page 10
of this manual.
To build a stack of two or three NetStacker Hubs, using
separate
NetStacker components,
you first need to install the individual
modules to create a Base Hub and one or two Expansion Hubs.
You can then build a stack by following the above procedure.