Installation guide

Page 9
Installing the NMM Lite
∆
Handle the board by its edges. Do not touch the
connectors or chips.
3
Screw in the thirteen standoffs, provided with the
NMM Lite daughter board, into the holes in the
mother board.
4
Position the NMM Lite (printed circuit side facing up)
over the mother board, placing its holes over the
standoffs on the mother board. Push down gently to
seat the board.
Figure 1 shows a top view of the NMM Lite daughter
board mounted on the mother board.
Figure 1 Top view of NMM Lite daughter board on mother board
5
Use the provided screws and a screwdriver to secure
the daughter board to the mother board. See Figure 2.
NMM Lite daughter board
Mother board
RS232/AMS Link connectors
Backplane connector