Installation guide

Page 24
NetStacker NMM Lite Installation Guide
Using Telnet You can use Telnet software (not included with the NMM Lite) to
interrogate and program an NMM Lite module in a NetStacker
hub. You can do this using any Telnet-capable computer, either
directly connected to the hub or over the network.
∆ Information on installing Telnet is not provided in
this manual. Refer to the documentation that
comes with the Telnet software.
The following list is a summary of the steps you need to perform
to use Telnet with an NMM Lite connected to a NetStacker hub.
❏ Install the image code on the AMS
❏ Upgrade the hub’s image code
❏ Establish a link with the hub using Telnet
This procedure assumes you‘ve already done the following:
❏ Installed AsantéView (version 2.3 or later) or
AsantéView Lite (version 2.3 or later) In-Band or
Out-of-Band software on the AMS
❏ Connected appropriate cables for In-Band or
Out-of-Band management
❏ Set hub DIP switches if needed
❏ Assigned an IP address to the hub
❏ Installed the Telnet application on your network
management station
Refer to the Telnet software documentation for installation
instructions. See the appropriate AsantéView User’s Guide for
information on installing and configuring the appropriate soft-
ware and hardware for using AsantéView.
Installing the Image Code Before you upgrade the image code in the NMM Lite with a
NetStacker hub, you need to install the image code files on the
AMS. Table 2 lists the files you need.
Table 2 NMM Lite Image Code File Names
Image File Configuration File
nshuxx.11x, nshuxx.20x, or later nsh.cfg