Installation guide

Page 18
NetStacker NMM Lite Installation Guide
1
Be sure the distance from the management station to
the hub is less than 50 feet.
2
Connect a straight-through RS232 cable (included
with AsantéView software) to the RS232 connector on
the NMM Lite.
Figure 7 shows a Macintosh RS232 cable being con-
nected to the NMM Lite RS232 connector.
Figure 7 Connecting to the Hub
3
Connect the other end of the connector to the
modem or COM port on the back of the AMS.
Figure 8 shows the symbol on the Macintosh that indi-
cates the modem port.
Figure 8 Macintosh Modem Port Symbol
With a Macintosh, you can run AsantéTerm (included with the
AsantéView management software) or another terminal emulation
program.See “Using AsantéTerm” on page 22 for more informa-
tion.
THIS EQUIPMENT COMPLIES WITH THE
REQUIREMENTS IN PART 15 OF FCC RULES FOR A
CLASS A COMPUTING DEVICE. OPERATION OF THIS
EQUIPMENT IN A RESIDENTIAL AREA MAY CAUSE
UNACCEPTABLE INTERFERENCE TO RADIO AND TV
RECEPTION REQUIRING THE OPERATOR TO TAKE
WHATEVER STEPS ARE NECESSARY TO CORRECT
THE INTERFERENCE.
RESET
NMM LED Legend
SNMP Traffic
CPU Active
Collision
RS232 Setup Mode
OOB Traffic
Misaligned, CRC error
RS-232
1 2
UP=PC
DOWN=TERMINAL
UP=THROUGH
DOWN=END
RJ45 (AMS LINK)
NetStacker DIP Switch Setting Instructions
For AMS Link connection: At the end of a daisy chain, or for
a single hub, set switch 1 to End, otherwise set switch 1 to
Through. Set 2 to Terminal
For RS232 terminal connection: Switch 1 setting
not relevant Set Switch 2 to Terminal
RS-232
RS232
DIN-8
To MAC