Installation guide

Page 17
Cable Connections to Other Devices
4
Use a null modem adapter to connect the modem
cable to the modem.
5
Set up the modem for auto-answer.
Using the Local
Management Port
You can use the RS232 connector on the NMM Lite as a local man-
agement port to gain terminal access to the NetStacker hub. This
section describes the steps involved. They are:
❏ Preparing the hub
❏ Connecting to the local management port
To prepare the hub for communication via the local management
port:
1
Set the hub’s DIP Switch 2 DOWN as shown in
Figure 6.
Figure 6 RS232/AMS Link Configuration DIP Switch Setting
DIP Switch 1 can be set to either UP or DOWN.
2
Reset the hub after changing the DIP switch setting.
You can either press the
Reset button on the NMM
Lite back panel or reset the hub remotely using
AsantéView Lite.
Follow these steps to connect an RS232 cable to the local manage-
ment port.
Set to
DOWN position
(DOWN = SETUP)
DIP Switch 1
ASANTEVIEW
OUT-OF-BAND
TERMINATION
DIP Switch 2
RS232/AMS LINK
CONFIGURATION