Installation guide

Page 14
NetStacker NMM Lite Installation Guide
Figure 4 Connecting hubs in an Out-of-Band daisy-chain
3
To enable termination in the out-of-band daisy-chain,
set DIP Switch 1
DOWN (END) on the end hub only.
4
On all other hubs in the chain, set DIP Switch 1 UP
(THROUGH).
∆ If you are managing only one hub, set DIP
Switch 1
DOWN (END).
5
Set DIP Switch 2 DOWN (SETUP) on all hubs.
6
If you change a DIP switch setting, you must reset the
NMM Lite. Press the Reset button on the back panel.
To connect an AsantéView Management Station to a hub, follow
the instructions in the next section.
For a summary of DIP switch settings, see Figure 9 on page 20 and
Figure 10 on page 21.
DIP Switch 1 DOWN 
(END)
on end hub only
Hub/Hub Stack 1
Hub/Hub Stack 2
DIP Switch 1 UP 
(THROUGH)
on all intermediate hubs
1 2
1 2
1 2
DIP Switch 2 DOWN 
(SETUP) 
on all hubs

End Hub/Hub Stack
Mac or PC
AMS Link 
Extender
RJ45
to Mac or PC
AsantéView
Management 
Station (AMS)
(up to 9 more 
intermediate hubs/hub stacks 
can be connected)