User`s manual

74 Asanté IntraCore 36000 Series
Console#
6.7 Configuring Access Control Lists
Access Control Lists (ACL) provide packet filtering for IP frames (based on address, protocol, Layer 4
protocol port number or TCP control code) or any frames (based on MAC address or Ethernet type). To filter
incoming packets, first create an access list, add the required rules, specify a mask to modify the
precedence in which the rules are checked, and then bind the list to a specific port.
6.7.1 Guidelines
An ACL is a sequential list of permit or deny conditions that apply to IP addresses, MAC addresses, or other
more specific criteria. This switch tests ingress or egress packets against the conditions in an ACL one by
one. A packet will be accepted as soon as it matches a permit rule, or dropped as soon as it matches a deny
rule. If no rules match for a list of all permit rules, the packet is dropped; and if no rules match for a list of all
deny rules, the packet is accepted.
The following restrictions apply to ACLs:
Each ACL can have up to 32 rules.
The maximum number of ACLs is also 32.
The average number of rules bound to the ports should not exceed 20.
You must configure a mask for an ACL rule before you can bind it to a port or set the queue or frame
priorities associated with the rule.
When an ACL is bound to an interface as an egress filter, all entries in the ACL must be deny rules.
Otherwise, the bind operation will fail.
The switch does not support the explicit “deny any any” rule for the egress IP ACL or the egress MAC ACLs.
If these rules are included in ACL, and you attempt to bind the ACL to an interface for egress checking, the
bind operation will fail.
The order in which active ACLs are checked is as follows:
1. User-defined rules in the Egress MAC ACL for egress ports.
2. User-defined rules in the Egress IP ACL for egress ports.
3. User-defined rules in the Ingress MAC ACL for ingress ports.
4. User-defined rules in the Ingress IP ACL for ingress ports.
5. Explicit default rule (permit any any) in the ingress IP ACL for ingress ports.
6. Explicit default rule (permit any any) in the ingress MAC ACL for ingress ports.
7. If no explicit rule is matched, the implicit default is permit all.
6.7.2 Setting the ACL Name and Type
Use the ACL Configuration page to designate the name and type of an ACL.