User`s manual

66 Asanté IntraCore 36000 Series
To add new VLAN members later, you can manually add secure addresses with the Static Address Table
(section 8.1 Setting Static Addresses), or turn off port security to reenable the learning function long
enough for new VLAN members to be registered. Learning may then be disabled again, if desired, for
security.
6.5.1 Guidelines
A secure port has the following restrictions:
• Cannot use port monitoring.
• Cannot be a multi-VLAN port.
• Cannot be used as a member of a static or dynamic trunk.
• Should not be connected to a network interconnection device.
If a port is disabled (shut down) due to a security violation, it must be manually re-enabled from the Port/Port
Configuration page (see section 7.2 Configuring Interface Connections).
Command Attributes
Port – Port number.
Name – Descriptive text.
Action – Indicates the action to be taken when a port security violation is detected:
• None: No action should be taken. (This is the default.)
• Trap: Send an SNMP trap message.
• Shutdown: Disable the port.
• Trap and Shutdown: Send an SNMP trap message and disable the port.
Security Status – Enables or disables port security on the port. (Default: Disabled)
Trunk – Trunk number if port is a member (section 9.9.1).
Configuring Switch Using the Web or CLI
Web
Click Security – Port Security. Set the action to take when an invalid address is detected on a port, mark
the checkbox in the Status column to enable security for a port and click Apply.