User`s manual

374 Asanté IntraCore 36000 Series
Press x to start downloading the new code file.
If using Windows HyperTerminal, click the “Transfer” button, and then click “Send File....” Select the
XModem Protocol and then use the “Browse” button to select the required firmware code file from your PC
system. The “Xmodem file send” window displays the progress of the download procedure.
The download file must be a binary software file for this switch.
After the file has been downloaded, you are prompted with “Update Image File:” to specify the type of code
file. Press R for runtime code, D for diagnostic code, or L for loader code.
If you select L for loader code, be sure the file is a valid loader code file for the switch. If you download an
invalid file, the switch will not be able to boot. Unless absolutely necessary, do not attempt to download
loader code files.
Specify a name for the downloaded code file. File names are case-sensitive, should be from 1 to 31
characters, not contain slashes (\ or /), and the leading letter of the file name should not be a period (.).
(Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
For example, the following screen text shows the download procedure for a runtime code file:
Select> R
Xmodem Receiving Start ::
Image downloaded to buffer.
[R]untime
[D]iagnostic
[L]oader (Warning: you sure what you are doing?)
Update Image File:r
Runtime Image Filename: run_1013
Updating file system.
File system updated.
[Press any key to continue]
To set the new downloaded file as the startup file, use the [S]et Startup File menu option.
When you have finished downloading code files, use the [C]hange Baudrate menu option to change the
baud rate of the switch’s serial connection back to 9600 baud.
Set your PC’s terminal emulation software baud rate back to 9600 baud. Press <Enter> to reset
communications with the switch.
Press <q> to quit the firmware-download mode and boot the switch.