User`s manual

354 Asanté IntraCore 36000 Series
10full Forces 10 Mbps full-duplex operation
10half Forces 10 Mbps half-duplex operation
Default
Auto-negotiation is enabled by default.
When auto-negotiation is disabled, the default speed-duplex setting is 100half for 100BASE-TX ports and
1000full for Gigabit Ethernet ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Usage Guidelines
To force operation to the speed and duplex mode specified in a speed-duplex command, use the no
negotiation command to disable auto-negotiation on the selected interface.
When using the negotiation command to enable auto-negotiation, the optimal settings will be determined by
the capabilities command. To set the speed/duplex mode under auto-negotiation, the required mode must
be specified in the capabilities list for an interface.
Example
This example configures port 5 to 100 Mbps, half-duplex operation.
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation
capabilities
16.230 stopbits
This command sets the number of the stop bits transmitted per byte. Use the no form to restore the default
setting.
Syntax Description
stopbits {1 | 2}
1 One stop bit
2 Two stop bits