User`s manual

346 Asanté IntraCore 36000 Series
Command Mode
Interface Configuration (Ethernet, Port Channel)
Usage Guidelines
This command defines the priority for the use of an interface in the multiple spanning-tree. If the path cost
for all interfaces on a switch are the same, the interface with the highest priority (that is, lowest value) will be
configured as an active link in the spanning tree.
Where more than one interface is assigned the highest priority, the interface with lowest numeric identifier
will be enabled.
Example
The following is sample output from the spanning-tree mst port-priority command.
Console(config)#interface ethernet ethernet 1/5
Console(config-if)#spanning-tree mst 1 port-priority 0
Console(config-if)#
Related Commands
spanning-tree mst cost
16.219 spanning-tree max-age
This command configures the spanning tree bridge maximum age globally for this switch. Use the no form to
restore the default.
Syntax Description
spanning-tree max-age seconds
no spanning-tree max-age
seconds Time in seconds. (Range: 6-40 seconds) The minimum value is the higher of 6
or [2 x (hello-time + 1)]. The maximum value is the lower of 40 or [2 x (forward-
time - 1)].
Default
20 seconds
Command Mode
Global Configuration
Usage Guidelines
This command sets the maximum time (in seconds) a device can wait without receiving a configuration
message before attempting to reconfigure. All device ports (except for designated ports) should receive
configuration messages at regular intervals. Any port that ages out STA information (provided in the last